I have a old school Kastan Pro, one of the very first designs from Kastan (IIRC) that I bought new back in 1993 time frame.
I haven't ridden my BMX since 1996 but I'm trying to get back into it however I bent the hell out of my old rims I had of an Elf bike. They are 20x1.5 wheels...
I'm looking at Complete wheels on Ebay to buy to replace them. My question is do I need 10mm or 14mm Axles? I know that when I take the wheel off the two nuts to take them off in the front or rear need a 14mm socket to take off. This is where I'm confused Any help is appreciated!!!
Also, any suggestions for wheels/hubs is appreciated!
(锕侊箒)~~~~----------------------------------------------------------------------
The Wrench size has nothing to do with it, measure the end of the axle where the nut goes on, probably 10mm, i think 14mm were on 48 spoke freestlye type wheels.
(锕侊箒)~~~~----------------------------------------------------------------------
If a 14mm wrench will fit on the nut then it is 14mm across the flats and the axel would have to be 10mm to provide 2mm thickness for the nut.
but I'm trying to get back into it however I bent the hell out of my old rims I had of an Elf bike. They are 20x1.5 wheels...
Any help is appreciated!!!